EA FC K9 car emergency starting power supply 12000mAh quick starting device

⏰Handling time>> Ship within 48-72 hours after payment.
😊Returns>> Fast refund for any dissatisfaction within 30 days. 100% money-back guarantee.

• BUY 2 GET 10% OFF
• BUY 3 GET 15% OFF
• BUY 4+ GET 20% OFF & FREE SHIPPING
• Add to cart to automatically receive discount

Please pay attention to this note:

The charge speed or discharge speed will be fast during the last 15% power of the jump starter. Please do not worry about this. This is the characteristic of high-rate lithium batteries, and it will not affect product quality and normal use.

Item description:
1: 600A Peak Current(3 seconds), Start Petrol Cars 5.0L or Below, Start Diesel Cars 3.0L or Below;
2: High Rate Polymer Lithium Battery, Car Emergency Start For 30 Times;
3: Work in -20℃~60℃; A Must and Reliable Need For Your Long Way Traveling;

4: Multifunctional Emergency Lights - Strobe Light / SOS Light.  You can use the SOS signal light strobe to attract attentions.  And you can use it as a torch with the built-in LED torch light function.

Specific:
Input: 5V-2A
Car boot voltage: 12V

Capacity: 12000mAh
Boot current: 400A
Peak current: 600A
Start engine: petrol up to 5.0L / diesel up to 3.0L
Cycle boot life: more than 3000 times
Full charging time: 2~3 hours
Operating condition: -20~60℃

Notice:

Matters needing attention (buyers must see)
The product has just been received, you must first turn on the flashlight to discharge, and then charge the product for more than 4 hours, and then start the car, because the product is empty. This operation can prolong the service life of the product!
Do not discharge and charge at the same time.
1. It is recommended to start the car with three bars or more than 60% of the power supply
2. Check whether the pile head of the battery is clean
3. Start the car with ordinary clip: Check whether the blue port of the clip is inserted to the end, whether the clip touches the positive and negative poles of the battery with the largest area, and whether the clip is stable and does not shake. First, clip the positive and negative poles of the clip to the positive and negative poles of the battery On, wait 2 to 3 minutes before starting the car. This operation can reduce the load on the power supply

Tips before use
【1】The car cannot be continuously ignited to start the car / or the key is not released, and the next start will be carried out after 30 seconds between each start
【2】The positive and negative poles cannot be reversed. Two clips cannot be connected short-circuited.
【3】Remove the clip within 30 seconds after successfully starting the car.
Violation of the above 3 points may cause the [fuse box] of the clip to burn out, please pay attention to the operation method.